3 replies to this topic

[superspeed]

I'm using a 360 nandflasher to program the chip. When I program it for the slim model the led stays off until I turn the console on. When I program it for the PHAT console it stays on when the console is plugged in and not turned on. I talked with VGC and was told its suppossed to be off and blink like it does with the slim. I am using the exctact same command as I do with the slim but the chip acts different with the phat .xsvf. I was told that since the led stays lit the the chip is not programmed right which I know is not the case unless the .xsvf on the 360nandflasher site for the PHAT model is not right. I can get them installed and working on slims just the phat is acting strange. The console I'm trying to glitch is a Jasper 16mb with a CB of 6751 I am using 360 multibuilder v.07 that had added support for the 6751 CB version. The rest I'm doing through nandpro 3.0 as far as the reading and writing.

I have tried 3 didderent Phat console not 1 will glitch and the chip acts the same way in all of them.

I have RGH'd 2 slims with them just fine.

[vgcrepairs]

did you set the solder jumpers on the stinger for the phat your working on?

there are allot of factors that go into glitching its not a simple straight forward act

Are you on the proper dash to glitch? is you dump perfect? is your ECC correctly made (6751 requires donor 6750)

the LED on stinger is on when blank, off when programmed. Once installed it will blink on and off when attempting the glitch.

[superspeed]

vgcrepairs, on 04 January 2012 - 11:49 AM, said:

did you set the solder jumpers on the stinger for the phat your working on?

there are allot of factors that go into glitching its not a simple straight forward act

Are you on the proper dash to glitch? is you dump perfect? is your ECC correctly made (6751 requires donor 6750)

the LED on stinger is on when blank, off when programmed. Once installed it will blink on and off when attempting the glitch.

Yes its a Jasper I have J1 and J2 both closed.

I'm using multi builder v.07 which builds the image for 14699 which is the dash I'm on. It also uses a donor CB to replace the 6751 with 6750.

When I program the chip the light stays on for the phat console and if I program for the slim it goes off untill the console is on.

The light does the same thing while hooked up to the nandflasher. In CMD in the nandpro folder I type "nandpro xsvf: Phat_max.xsvf the light goes dim for a min then bright green. If I program with the trinity_max.xsvf the led goes off? It says either way the it was successfully programmed.

[vgcrepairs]

I did 2 falcon DVD key recoveries yesterday no issues using the xsvf files at all