Stinger install ?

Started by superspeed, Nov 26 2011 12:03 PM

You cannot reply to this topic

4 replies to this topic

#1
superspeed

Posted 26 November 2011 - 12:03 PM

Member

Members
20 posts

Can I use the cable that is used to program the chip to install it? Also is there a way to downgrade the CB version so we will no longer need the chip?

#2
vgcrepairs

Posted 26 November 2011 - 02:10 PM

Super Moderator

Moderators
776 posts

you CAN NOT downgrade

if you want to cut up the cable to use for install go for it

#3
superspeed

Posted 26 November 2011 - 02:22 PM

Member

Members
20 posts

vgcrepairs, on 26 November 2011 - 02:10 PM, said:

you CAN NOT downgrade

if you want to cut up the cable to use for install go for it

Ok so I can use the input used to to program the chip instead of using the pads?

#4
vgcrepairs

Posted 26 November 2011 - 05:51 PM

Super Moderator

Moderators
776 posts

huh?

#5
superspeed

Posted 26 November 2011 - 07:22 PM

Member

Members
20 posts

vgcrepairs, on 26 November 2011 - 05:51 PM, said:

huh?

I'm talking about using the harness instead of the A, B, C, D, and E, pads on the stinger. As in clipping the black end off only and leaving the end that plugs into the stinger chip and running the wires on the harness to the correct locations.

Back to Hardware