3 replies to this topic

[Twinbird]

Hello,

I have a Zephyr console that I JTAGed using the Maximus 360 NAND Flasher. I have everything set-up properly (XexMenu, FSD, DashLaunch, etc.) and it's working great for the most part. However, most of the time I go to turn the Xbox on, I get 1 flashing red light (secondary error code 1033). I checked over all the solder connections and they are good (nice shiny round solder, properly connected, no shorts, etc.). Bridging JMPA on module C made no difference. Could it be that I need a different value resistor (like the NAND-X board, which lets me choose between 0, 330 and 440 Ohms)?

Thanks.

[vgcrepairs]

your wire length might be too long, I recomend you remove MODULE C and install diodes on bottom of mainboard like this

[Twinbird]

Thanks for the reply. I have found the solution though. I read through these two pages:

http://www.hackingju...s-boot-up-3294/

http://www.team-xecu...ead.php?t=54808

I just soldered to the Aud_clamp instead of the RF board. I had to create a new freeBOOT image using Jtag Tool (just checked the "Aud_clamp SMC" box in the FreeBoot section) and flash it to the NAND. No more RRoD!

Also, the wire is not too long, it is the one the came with the 360 NAND Flasher package. I still have module C soldered to the board (as well as modules A and B).

[kila574]

how is that i have the same problem i did 2 xenon and a falcon and i get the same thing i flash them and when i go to the tv to get my key i just get a black screen