2 replies to this topic

[arcelio]

Hi I'm a newb. I bought the xtractor pro v 2.3 and the vampire2.0. I don't know how the wire goes from the vamp to the xtactor so I cut the board I placed the rebuilt board. I sardered the board, I tried to read the drive at one point i saw the drive ver firmware ver. I tried to save the firm but no luck. so I shut everything off and tried again. Now my drive has no power light on 93450c. Did I burned a fuse? I hav no power what so ever. Did I put the wires wrong on the vamp and xtracter. there are no pics on how they go. So I put everything back and sawderthe cuts but no luck. how can I get power back on my drive?

[vgcrepairs]

arcelio, on 15 November 2010 - 05:06 PM, said:

Hi I'm a newb. I bought the xtractor pro v 2.3 and the vampire2.0. I don't know how the wire goes from the vamp to the xtactor so I cut the board I placed the rebuilt board. I sardered the board, I tried to read the drive at one point i saw the drive ver firmware ver. I tried to save the firm but no luck. so I shut everything off and tried again. Now my drive has no power light on 93450c. Did I burned a fuse? I hav no power what so ever. Did I put the wires wrong on the vamp and xtracter. there are no pics on how they go. So I put everything back and sawderthe cuts but no luck. how can I get power back on my drive?

all the picture and instructions are located at www.360xtractorpro.com

Most likely you blew the mosfet on the board

[arcelio]

vgcrepairs, on 15 November 2010 - 09:18 PM, said:

all the picture and instructions are located at www.360xtractorpro.com

Most likely you blew the mosfet on the board

IF- I REPLACE THE MOSFET WILL IT POWER ON WHERE CAND IT BUY ONE AND WHERE IS THE MOSFET ON THE BOARD